2017部署思科无线企业网络考试要点
WIDEPLOY(300-365)考试检验考生是否具备实施基于无线网络的.可适用思科控制器以及支持高可用性的、QoS、组播和移动服务的统一交换架构的能力。下面是小编整理的考试要点:
1.0 Implement QoS for Wireless Applications13%Hide Details
1.1 Describe and implement general considerations for wired QoS
1.1.a Configurations
1.1.b DSCP/IP precedence to 802.1p mapping
1.1.c Voice VLAN
1.1.d Trust boundaries
1.2 Describe and implement the appropriate wireless QoS deployment schemes
1.2.a 802.11e / WMM
1.2.b Mapping-wired to wireless
1.2.c Alloy QOS
1.3 Configure infrastructure QoS for wireless clients
1.3.a CAC
1.3.b TSPEC
1.3.c EDCA parameters
1.3.d Queues
1.3.e Bandwidth control and override
1.4 Implement AVC
1.4.a Configure AVC
1.4.a.[i] Profiles
1.4.a.[ii] Netflow/NBAR2
1.4.b Monitor AVC
1.4.b.[i] Controller
1.4.b.[ii] PI
2.0 Implement Multicast over Wireless13%Hide Details
2.1 Describe general multicast concepts
2.1.a PIM
2.1.b Cisco Group Management Protocol
2.1.c IGMP snooping
2.1.d RP
2.2 Describe implications for multicast in 802.11
2.2.a Highest mandatory data rate
2.2.b Unicast and multicast modes
2.2.c Roaming
2.2.d Controllers having same CAPWAP multicast group
2.2.e Video stream (reliable multicast)
2.2.f mDNS
2.3 Configure multicast in a wireless network
2.3.a Infrastructure multicast group
2.3.b IGMP snooping on the controller
2.3.c Video stream (reliable multicast)
2.3.d Switch peer group / Mobility group multicast
2.4 Configure mDNS
2.4.a mDNS gateway
2.4.b LSS
2.4.c Service advertisement
2.4.d MAC priority
2.4.e AAA override
2.4.f ISE portal
2.4.g Static advertisements on converged access
2.4.h mDNS profiling
3.0 Implement High Density13%Hide Details
3.1 Design for High Density
3.1.a High client count (high capacity)
3.1.b High AP count (high density)
3.2 Implement RXSOP
3.3 Implement enhanced roaming
3.4 Implement AP Groups
3.4.a RF profiles
3.5 Implement interface groups
3.6 Implement client limits
3.6.a Per Radio
3.6.b Per WLAN
3.6.c Per Interface
4.0 Design and Deploy WLAN Infrastructure for Mobility18%Hide Details
4.1 Describe the impact of client VLAN assignment on mobility
4.1.a AP group VLANS
4.1.b Identity based networking
4.2 Minimize inter controller roaming
4.3 Describe mobility control plane architectures
4.4 Describe mobility tunneling process
4.4.a Formation
4.4.a.[i] Ability to identify the tunnels created
4.4.b Tear down
4.4.c Messaging
4.4.d Handoff types
4.5 Implementing client mobility
4.5.a Switch Peer Group (SPG)
4.5.b Mobility groups
4.5.c Mobility lists
4.5.d Anchoring
4.5.e Virtual interface continuity
4.5.f Mobility Optimization (11k/11v)
4.5.g Verify resulting mobility tunneling structure
5.0 Implement Cisco MSE Architecture12%Hide Details
5.1 Describe Cisco MSE capabilities and integration with wireless network architecture
5.1.a Context aware
5.1.b Adaptive wireless IPS
5.1.c Analysis
5.1.d CleanAir
5.1.e Scalability
5.2 Describe location techniques
5.2.a Angulation
5.2.b Cell of origin
5.2.c TDoa and ToA lateration
5.2.d RSS lateration
5.2.e Pattern recognition
5.2.f RF Fingerprinting
5.2.g Compare probe based location vs data frame based location
5.2.h Bluetooth Low Energy (BLE)
5.3 Identify the relevant parameters required Initialize MSE for network operations
5.4 Implement base location services
5.4.a Calibration procedure
5.4.a.[i] PI based
5.4.a.[ii] Ekahau based
5.4.b Complex environments
5.4.b.[i] Mixed use environments
5.4.b.[ii] Complex RF environments
5.4.b.[iii] Small areas ( i.e new presence capabilities)
5.4.b.[iv] Multi-floor facilities
5.4.b.[v] Recalibration
5.4.c NMSP
5.4.d Synchronization
5.4.e History parameters
5.4.f Tracking parameters
5.4.f.[i] Active RFID tag
5.4.f.[ii] WiFi-Devices
5.4.f.[iii] Active Interferes
5.4.f.[iv] Rogue devices
5.5 Implement advanced location services
5.5.a Analytics
5.5.a.[i] Location (zone based)
5.5.a.[ii] Presence (site based)
5.5.b Visitor connect
5.5.c Describe AppEngage
5.5.d Facebook for Wi-Fi
5.6 Integrate MSE with PI
5.6.a Identify the relevant components to integrate the MSE with PI
5.6.b Identify the relevant steps to Integrate MSE with PI
5.6.c Identify the relevant steps required to Maintain MSE
6.0 Design and Implement FlexConnect Architecture12%Hide Details
6.1 Compare and contrast the components of FlexConnect architecture
6.1.a Local switching vs Central switching
6.1.b Local Auth vs Central Auth
6.1.c Connected mode vs Standalone mode
6.2 Describe and implement the capabilities of a FlexConnect group
6.2.a VLAN mapping
6.2.b ACLs
6.2.c AP Image upgrade
6.2.d Authentication and key management
6.2.e Central vs Local DHCP
6.3 Describe the impact of FlexConnect architecture on roaming
6.3.a ACLs
6.3.b Authentication
6.3.c Key management
6.3.d Real time application
6.4 Describe and implement Office Extend operation
6.4.a Configuration
6.4.a.[i] Controller
6.4.a.[ii] AP
6.4.b Split tunneling for printing and general traffic
7.0 Implement Controller and AP High Availability10%Hide Details
7.1 Configure the wireless network for high availability
7.1.a LAG vs Port based
7.1.b Backup primary and backup secondary outside of mobility group
7.1.c Anchor controller redundancy
7.2 Configure high availability for the AP
7.2.a AP fallback
7.2.b AP prioritization
7.2.c Legacy primary ,secondary, and tertiary
7.3 Configure high availability for the Controller
7.3.a AireOS
7.3.a.[i] Stateful switch over (SSO)
7.3.b IOS-XE
7.3.b.[i] Stateful switch over (SSO)
7.3.b.[ii] Stacking
8.0 Wireless Bridging (MESH)10%Hide Details
8.1 Describe the following MESH AP modes of operation
8.1.a RAP
8.1.b MAP
8.1.c Flex on MESH
8.2 Describe the considerations for a MESH deployment
8.2.a Hop count
8.2.b Backhaul caveats
8.2.c AP authorization
8.2.d Outdoor RF considerations
8.2.e VLAN transparent bridging
8.3 Describe the convergence of a MESH network
8.3.a Cisco AWPP
8.3.b Bridge group names
8.3.c Parent selection
8.3.d Fast convergence modes
8.3.e Re-convergence
8.4 Implement workgroup bridge
8.4.a Proprietary
8.4.a.[i] Reliable multicast
8.4.a.[ii] Roaming
8.4.b Universal
8.5 Describe the passive client feature
8.5.a No IP address learning
8.5.b Third party WGB support
-
七种计算机认证考试简介
眼下,各种计算机证书可是宝贝,有了这一纸证书,招聘台前腰板儿都要硬三分。以下是小编为大家介绍七种计算机认证考试,欢迎大家前来了解!全国计算机应用技术证书(NIT)考试它是教育部考试中心推出的以全体公民为对象的非学历性的计算机考试。这个考试注重培养学员使用...
-
计算机二级office考试上机必知内容
成为一名程序员首先要掌握一种主流编程语言,学习任意一种主流的编程语言,例如C++语言。下面是小编整理的.关于计算机二级office考试上机必知内容,欢迎大家参考!一、考试内容要求:1、掌握计算机基础知识及计算机系统组成2、了解信息安全的基本知识、掌握计算机病毒...
-
2017年计算机二级office题库选择题
2017年3月计算机等级考试定于3月25日-28日举行,下面是小编整理的一些关于计算机二级office题库选择题,希望对各位考生有所帮助!1.程序流程图中带有箭头的线段表示的是()。A.图元关系B.数据流C.控制流D.调用关系答案:C【解析】在数据流图中,用标有名字的箭头表示数...
-
2016年《构建H3C数据中心网络》模拟试题及答案
1.数据中心分类中,按TIA-942可以分成()级,按国标GB50174可以分成()级?A、3,3B、3,4C、4,3D、4,4正确答案:C2.数据中心的互联网出口带宽优化主要包括如下哪些方面?(选择一项或多项)A、恶意流量过滤B、专线备份管理C、不同ISP用户就近选择相应服务器D、内网用户就近选择...